PIPE FITTER TRAINING AND PLACEMENT

The PipeFitter/Fabricator Training for Oil and Gas Industry will cover the points are fallows:-
Introduction to Oil and Gas Industry, Standards, specifications and HSE Requirements.
Basic information and definition of Piping Drawings ISO, P & ID, GA, SECTION and PLAN.
Basic information and definition of Piping and related fittings to be used during Fabrication as per Joint type (But Welded, Socket Welded and Threaded.)
Information of tools and tackles to be used during Fabrication and Installation.
How to Study the Drawing s symbol (Fittings, valves, instruments, Insulation, Tracing and Joints Type) design codes, standards, Hydro test & Pneumatic test Pressure Knowledge and making of templates as per Isometrics.
Basic information of Spool Mark-up and Joint Mark-up, Bill of Material Preparation as per drawing.
Calculation method of pipe and fittings length for making spools as per drawing elevation, Direction like East, West, North, South, Up, Down and Rolling Offsets.
Basic information about Mark-up of pipe length, Edge preparation, Fit-up Procedure and Inspection as per standard and acceptance criteria.
Basic information about various types of piping supports.
Making of Isometric as per site survey (As built) Layout Drawings as per requirement.
Calculation and making method of manually made fittings like Saddle tee, Lateral tee, Miter Elbow, Y Branch and Trunion Sports.
Physical Demonstration of Mark-up, Edge Preparation, Fit-up and Dimensions Checkup of piping spools fabrication as per drawings.
Physical Demonstration and calculation of Miter elbow, Tee, Y branch and Trunion Supports Layout and marking method.
Demonstration of Formula and calculation method of various requirement for fabrication during piping.
Hydro testing and Pneumatic Testing Preparation.